Hello, welcome to Zhejiang Jie Li Da HVAC Technology Co., Ltd. official website!


You are here:Home > News

How to use [to warm the water separator] in order

time:2017-02-23 hit:3243

After the end of the annual heating period, the boiler pipe water in the warm pipe network should be discharged. Because the boiler pipe water contains a lot of slime, impurities, rust and other small particles, water turbidity, and geothermal pipe network inside the very small, such as the boiler stop gas, the pump stops running, the original sewage impurities, will stay in the pipe network Up to 7 months, and the water containing calcium, magnesium, salt and other material precipitation will produce a hard scale hanging on the inner wall of the geothermal pipe network, bending more serious, even by pressurized water is not washed out The Long-term scaling will not clear the flow will be reduced, poor water flow, lower heat radiation value, resulting in pipe network blockage, can not be cleaned, the entire warm pipe network will be scrapped.

Moreover, the use of heating is different from ordinary heating
First, the first run should be gradually injected into the hot water for the first time to start the geothermal, in the hot water, the first half of the open water heater water supply total loop valve, the hot water temperature gradually increased into the pipeline cycle. Check the water separator interface with or without the same, and one by one to open the sub-valve to open the water.如有To warm the water separatorAnd pipeline leakage should be promptly closed for the return of the water supply valve and timely contact with developers or geothermal companies.

Second, the first way to run the exhaust method has said
During the first run of the ground warm, due to the pressure and water resistance in the pipeline is easy to produce air plug, resulting in water supply is not recycled, the temperature is not equal, should be done by road exhaust. Method is: turn off the heating of the total return valve and the loop control valve, first open the water separator on a control valve, and then open the warm water separator on the back of the exhaust valve exhaust, after the exhaust air And then close the valve, while opening the next valve. And so on, each way the air is drained and then all the valves open, the system is running.
Again, the outlet pipe should not heat the filter.

Each oneTo warm the water separatorBefore the are equipped with a filter, when the water is too much impurities, it is necessary to clean up the filter. When the filter is too much impurities, there will be a water pipe is not hot, hot and not hot and so on, usually a year to clean a filter. Method is to close all the valves on the warm water separator, use the live wrench counterclockwise to open the filter cover, remove the filter for cleaning, after cleaning the original installed on the back. Open the valve, the geothermal system can work properly. If the temperature is less than 0 ℃ when the temperature is below 0 ℃, it is recommended that the user should drain the water in the geothermal coil to prevent the freezing of the pipeline.

Related Products Recommended: Zhuji water separator http://www.chjld.com/index.php?s=/products.html

Home  |  Jie Lida water separator  | about us  |  Products  |  Download  |  Careers  |  Technical Support  |  contact us

浙ICP备10003325号 Zhejiang Jie Lida Pipe Industry Co., Ltd Contact: Li Yunhai mobile number:13606852630 phone:0575-87669088 fax:0575-87669008

Address: Zhejiang Province Zhuji City shop town Yang Yan Road Zip code:311835   Backstage management